Cutting and engraving wellLesson 7 of 19
Auto-nest parts
Fit more parts on the sheet so less of it goes in the bin.
Parts land where they were dropped, with gaps between them going to waste.
Select the lot and let the tool pack them.
The same parts come off a smaller area of sheet.
Every setting
14What each number in the dialog means, and where it starts.
Gap between parts (mm)
Cut width (mm)
Material thickness (mm)
Sheet width (mm). 0 fits the sheet to the parts.
Sheet height (mm). 0 uses the full bed.
Let parts be flipped over to fit
Parts needing more sheets open a tab each.
Keep this much sheet clear along every edge, for clamps and uncut stock.
How many of each part. The extras are real copies.
Packs around whatever you did not select, at the same gap.
Turn parts in steps of (degrees)
Which packing to use. Shuffle in the preview tries another one.
What it is
Packs selected shapes onto the sheet with rotation and spacing to cut waste.