Making things that fit togetherLesson 13 of 16
Holding tabs
Keep small parts from dropping through the bed before the job ends.
1
Start with parts that would fall free the moment their outline finishes.
2
A short gap is left in each outline, so the part stays joined to the sheet.
3
Lift the whole sheet off the bed and snap the parts out by hand.
Every setting
3What each number in the dialog means, and where it starts.
Tab width
Width of each tab (mm)
Tabs per shape
Tabs around each shape
Layer
Layer to add tabs to
What it is
Breaks a short uncut gap into every closed cut shape so parts stay held in the sheet. Snap them free by hand after the job.
16 lessons