Cutting and engraving wellLesson 12 of 19
Fill with lines
Shade a shape with engrave lines instead of leaving it an outline.
1
Start with a closed shape.
2
It fills with parallel lines that stop at the outline.
3
The shape engraves shaded rather than outlined.
Every setting
5What each number in the dialog means, and where it starts.
Spacing
Gap between fill lines (mm)
Line angle
Fill line angle (degrees, 0 is across)
Cross
Add a second pass at 90 degrees for a crosshatch pattern
Inset
Keep the fill this far inside the edge (mm)
Layer
Layer to put the fill on
What it is
Fills closed shapes with parallel scan lines at a chosen angle, clipped to the shape's boundary. Enable cross for a two-direction crosshatch in one pass.
19 lessons