Cutting and engraving wellLesson 1 of 19
Focus test
Find the height that puts the beam at its sharpest on this material.
Set the material on the bed and cut the test lines.
The machine does not move the head for you: raise it by the step between lines, and one comes out thinner than the rest.
Set the head to the height of the cleanest line and use it for the job.
Every setting
8What each number in the dialog means, and where it starts.
How many lines to cut
Length of each line (mm)
Gap between lines (mm)
Height of the end ticks (mm)
Focus height of the first line (mm)
How much the focus height changes per line (mm)
Left edge (mm)
Top line (mm)
What it is
Draws one line per focus height with the height written beside it. The machine does not raise the head for you, so raise it a step between lines.