Beam width check
Measure how wide the burnt dot is, so engraved edges land where you drew them.
1
Engrave the test lines on the material you engrave most.
2
Measure the width of a burnt line under good light.
3
Enter the width you measured, and every engrave after it lines up with the drawing.
Every setting
5What each number in the dialog means, and where it starts.
Speeds to test
Speeds to test, separated by commas (mm/s)
Line length
Length of each test line (mm)
Spacing
Gap between test lines (mm)
Start x
Left edge (mm)
Start y
First line down the sheet (mm)
What it is
Cuts one line per speed, so you can measure the beam width at each.