Cutting and engraving wellLesson 4 of 19
Calibrate axis
Fix cuts that come out slightly bigger or smaller than the size you typed.
1
Cut the calibration square on a scrap of the material you use most.
2
Measure the square you cut and compare it to the size on screen.
3
Enter what you measured, and the machine's step size is corrected for every job after.
Every setting
4What each number in the dialog means, and where it starts.
Square size
Square size (mm). Measure this edge after cutting.
Centre mark
Centre crosshair size (mm)
Start x
Left edge (mm)
Start y
Top edge (mm)
What it is
Cuts a square of a known size. Measure both sides against what you asked for, then correct the step size in Machine settings.
19 lessons